1 |
GENERAL |
|
The following procedures are applicable to Komy Mirror. |
|
2 |
INSTALLATION |
|
A |
Throughly clean any grease, oil or dust
out of installation area of the mirror isopropyl alcohol. |
|
B |
Mark mirror location up per applicable installation drawing.
|
Fig.1
Fig.2 |
|
C |
Remove entire seal peel covering
adhesive tape on the back side of mirror (fig.1).
|
|
D |
Locate the mirror in place per location mark
carefully and press it firmly with force more than 5kg/cm2.
NOTE :
Careful placement and installation are required because of tough relocation and removal once the mirror has been mounted. |
|
|
E |
Check the mirror for correct visibility (Fig.2). |
|
F |
Clean the mirror surface with ordinary neutral cleaning
agent. |
3 |
REMOVAL (IF NECESSARY) |
Fig.3 |
|
A |
Stretch a very thin steel wire (ex. piano wire) tautly.
Then, place the wire at the top of
the mirror.
|
|
B |
Get the wire into between adhesive tape and the wall which the mirror is placed (Fig.3). |
|
C |
Peel the mirror off gradually and carefully to avoid
possible damage to the wall (Fig.4).
|
Fig.4 |
back
to top