Q&A

HOME » Products » Q&A

1 GENERAL

The following procedures are applicable to Komy Mirror.

2 INSTALLATION

  • A    Clean any grease, oil or dust out of installation area of the mirror isopropyl alcohol.
  • B    Mark mirror location up per applicable installation drawing.
  • C    Remove entire seal peel covering adhesive tape on the back side of mirror (Fig.1).
  • D    Locate the mirror in place per location mark carefully and press it firmly with force more than 5kg/cm2.
  • E    Check the mirror for correct visibility (Fig.2).
  • F    Clean the mirror surface with ordinary neutral cleaning agent.
NOTE :
Careful placement and installation are required because of tough relocation and removal once the mirror has been mounted.


Fig.1

Fig.2



3 REMOVAL (IF NECESSARY)

  • A    Stretch a very thin steel wire (ex. piano wire) tautly. Then, place the wire at the top of the mirror.
  • B    Get the wire into between adhesive tape and the wall which the mirror is placed (Fig.3).
  • C    Peel the mirror off gradually and carefully to avoid possible damage to the wall (Fig.4).

Fig.3

Fig.4



Top